Tecumseh LH358 Engine

#1
Hey Guys.

Just got this engine, and I am trying to mount the torque convertor, but the bolt will not go into the center of the drive shaft.

It's apparently a M10 bolt, or so it seems... But we cannot figure out the pitch of the threads.

We have currently tried 1.25 and 1.50 threads, and neither one of them go into the drive shaft. They start to thread, but then stop.

Can SOMEONE please help!?

Thanks!!
 
#7
You guys were totally right. The inner threads of the horizontal shaft are 3/8-24 NF thread. Appreciate you guys a bunch! Thank You!
 
Top