honda

  1. Brandonsmanco

    My First Build! Manco Streaker, Honda Gx160

    Hello everyone, very excited to be a part of this group. I picked up my first build and first minibike today, it's a Manco Streaker! With a Honda GX160 5.5HP on it. I paid $325. First Impressions, the motor turns over first pull, and it's quiet due to the stock muffler. I'm wondering is there...
  2. P

    Carburetor for late '69 z50a

    Everyone was so helpful on my last post that I thought I'd try another... I am looking for recommendations on a replacement carburetor for my late 1969 Honda z50a mini trail. I'm hoping to find something that is a bolt on replacement for the stock carb that can be used as part of my...
  3. L.skynrd

    Minibike with front/Rear Shocks

    Hey guys, I scored this minibike with a 4 horse honda off of facebook marketplace. It doesn't have any branding on it, does anyone have any idea as to what it may be
  4. districtmotors

    Honda Wet Clutch + GX140 Engines + Parts (Will Ship)

    Hello! Again...forgive me if this is the wrong area to post. I was told last time I need 5 relevant posts to see certain categories. (My hope is you are less forgiving than my other main board...Turbobricks) Anyhow, I acquired a lot of Honda parts and ultimately decided to go another...
  5. normale spatborden.jpg

    normale spatborden.jpg

    Honda with standard fenders.
  6. chaly spatborden.jpg

    chaly spatborden.jpg

    Honda with chaly fenders. Aka German fenders.
  7. 20201110_195147.jpg

    20201110_195147.jpg

    What a bunch of wires.
  8. 20201110_193634.jpg

    20201110_193634.jpg

    Previous owner was very talented with soldering...
  9. 20201110_172312.jpg

    20201110_172312.jpg

    RFY shocks, these will replace the original shocks. I might have to open them up to see if there's enough oil and or air pressure in them. $50,- shipped.
  10. 20201110_172213.jpg

    20201110_172213.jpg

    New, small, led blinkers. Flowing light.
  11. 20201110_172124.jpg

    20201110_172124.jpg

    Fork boots.
  12. 20201110_170347.jpg

    20201110_170347.jpg

    Start button. This might be located where the key switch is originally.
  13. 20201105_132201.jpg

    20201105_132201.jpg

    Kepspeed led headlight will be replaced with this headlight of a Puch moped.
  14. 20201024_155729.jpg

    20201024_155729.jpg

    Wheel hub with new bearings and shaft installed.
  15. 20201024_154526.jpg

    20201024_154526.jpg

    Pre heating wheel hub before placing the bearings.
  16. 20201024_145650.jpg

    20201024_145650.jpg

    Making a new shaft.
  17. 20201024_140914.jpg

    20201024_140914.jpg

    Modify wheel hub to make it accept larger wheel bearings.
  18. 20201023_165622.jpg

    20201023_165622.jpg

    Wheel hubs. Replacing wheel bearings.
  19. 20201017_165009.jpg

    20201017_165009.jpg

    Seat appears to be of center. Tail light missing glass.
  20. 20201017_164804.jpg

    20201017_164804.jpg

    Lots of work get all this right.
Top