I am replacing a 7hp engine that got blown up last summer in my Tote Gote 780 Nova. The clutch is still good. My plan was to just pull off everything from the 7hp and put on the 8hp short block, but sounds like the 7hp crankshaft won't work. Any suggestions?
I found a 8hp IC shortblock, but the output shaft is Tapered Tapped 5/16-24
4-11/32 Measured from Flange mounting face on ball bearing, horizontal crankshaft engine. The block was used on Model Series: 195400.
I was hoping to figure out which crankshaft would work to replace it so I can run a...
I have answered some of my own questions with some help from a member here. I found these too websites below that list the dimensions and the crankshafts that come with shortblocks respectively...
Couple of questions - Are the 7hp and 8hp crankshafts interchangeable? (7hp is a plain bearing, while the 8hp is a ball bearing)
Does anyone know of a part listing for 8hp crankshafts for Model Series: 195400? That lists the dimensions and part numbers of the crankshaft.
I just went down to the motorcycle salvage and dug around until I found a cable that would work. Took some digging, but all said and done I had a hand full of cables for like 7 dollars.
I have a 780 Nova that needs the a motor replaced. The old 7hp briggs on it now needs to be replaced and I have been unable to find anything that will work. I am finding lots of Tecumseh engines though. Does anyone know if I can put a 7-8 hp Tecumseh in a 780 Nova?
I have a Haxco HA 251 axle. How do I take the axle apart? I got it opened up, but I can't get the gears out to clean them up. Does anyone have any experience with these axles?
Selling my really nice Model B. All original. Has the canvas bag and head light. The bike needs a new paint job and then its prefect. The engine runs really nice. The Gote was stored indoors for most of its life and has been since I have owned it. I don't want to ship. Buyer is to arrange pick...
I am looking for more information about the long flat exhaust that some of the super broncs' came with. KC57 told me they were a Taylor muffler model 800 series. Mine has no guts. Was there any to begin with? Does the muffler say spark arrestor somewhere on it? In Idaho they like to stop people...
I made the mistake of laying them down on there side and oil leaked out. I can't really tell how much. So I am afraid to use them until I know they are safe. Does anyone know how to rebuild them? Take them apart? What oil to use?
Any help would be greatly appreciated.
Yeah I did. Then I picked up a Dune Gote and forgot all about everything else. Sorry. I have a picture or two, but they are big. I am too lazy to compress them down. PM me your email and I will send the pics.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.