First off, this will probably take several posts to get started. I have a lot of pictures.
I'm a new guy here so I figured I'd do a build thread on my latest project. It's a Cat 250x that I bought a few weeks ago for 50 bucks...
The engine was wasted from sitting outside uncovered for...
I need a new rear sprocket for my Cat, but it seems to have a weird smaller bolt pattern than the aftermarket ones I see everyone selling. I haven't mic'd it exactly yet but it's close to 2.5 inches. It seems most of them I am finding are on a 2 13/16 bolt circle or similar.
Any pointers on...
I'm a new guy on here so I figured I'd try and offer a little tech to maybe help some folks out.
I've read on here where some guys are struggling with loose choke slides on these carbs. Some even replaced the whole carb with a different setup just because of this issue.
As you probably...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.