connected

Need a little advice on what to do to get my carb running smooth again? Did the air filter and header pipe knowing it would need a little adjustment but just don't know what is right? I have a .035 jet should I just replace that? Some say the e-tube? not sure would like some input! I was hitting...

The engine is about 6 months old. It gets fire to the plug and the gas is going to carb so i figure its the on/off wiring on motor that is connected to kill switch but I am not sure. Has anyone had this happen to them? Any suggestions?

I've searched and searched and found that I can easily remove the low oil sensor issue by just snipping the wire but I can't seem to find any info on what that small square module does that is connected to the oil sensor. It appears to me that after cutting the sensor wire I should be able to...

This is my first experience working on these little engines. So this has me baffled. Motor is a 3.5 Briggs but it will only run when the plug wire is off the plug so it is a 1/4" away, arcing. But not when it's connected.:confused: I'm giving this to my Grandson tomorrow so help is needed...