Hello,
I am looking into a laser chain alignment tool. They seem to be kinda pricey for what they are. Does anyone make something that you can just attach a laser pointer to? That would seem to be the cheaper way to go. I don't feel like spending 90 bucks on one of these. For that matter, do...
Chrome fenders. $150 for the set. Chrome on rear fender bracket isn't as good as the fender. Front fender only has one original bracket I believe.
Chrome rupp shocks. Measures 11" eye to eye. Chrome is good and shocks move freely.
$75
Prices not including shipping
I got a hell of a deal on a Flying"O" MTD with a HM80 3/4" shaft tiller engine with reverse shaft, the engine will power a Super Tyke roller I have. I need the jackshaft bracket and clutch if possible bit would take a bare bracket and build it up. I also need fenders and some cheap 12" eye to...
I need a pair of rear shocks for a "Rupp Rat" that I am working on. Lots of rust is ok, just as long as they work. They are 13" eye to eye. I'm trying to keep this original, but, it will be rusty.:laugh: Well, maybe a clone.:laugh:
Went thru one of my parts bins and here's what I came up with to sell:
two pairs of shocks. One set of Sebacs, 11 3/4" eye 2 eye. One set (unknown brand) 10 3/8" eye 2 eye. $35 shipped for both sets. (includes a third set of Sabecs for parts).
One baby set of General Junior Jumbo tires. Size 8...
I picked up a set of Sebacs recently that were not of the usually minibike variety. I'm assuming they might be from a moped. Can anyone confirm? They are the same length as the common minibike variety, about 13" but have a different eye casting design on each end. They are genuine Sebac brand...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.