piston/rings

Currently building up HS40's and wanted to note a change that Tecumseh made regarding pistons and rings. In later years Tecumseh started using thinner rings. The piston size on an HS crossed with some of the OHH engines (as does alot of other internals) so they offered that piston/rings as an...

thanks for lookin... I have a power products 1000 engine Ser#21605 that I am working on that I got from eBay. anyone know what year it is?? when I got it, it ran ok but when I took it apart I found the piston skirt was cracked away, and the bearings were not original.-There from Japan-...

NOS West Bend 510 piston/rings Bought the wrong parts awhile back. These are for a 510, cool old packaging:thumbsup: I know they say outboard, the numbers cross for any 510! $18 shipped

Hi, I had a cast iron sleeve put into briggs 5hp engine, along with valve/lifter guides, new valve seats, an ARC rod, and a raptor 3 piston and rings. The engine runs good and still runs good, but before the end of the summer it started using excessive oil. This engine is not raced and in fact...

I have this I/C engine I've been tearing down and I need some advice. I already planned on honing the bore and replacing the rings, but should I replace the piston while i have it out? It has some (a moderate amount) of carbon buildup. What should I do? New Piston + Rings + Hone? Or just Rings +...