power

Vintage Kart Vintage Mini Bike U s Motor Power Inc Power Bee 58041 | eBay So when he found it in the original box, a Tecumseh pull starter must have migrated in there, while the gas tank and mount migrated out of there. While all that was happening, the engine rebuilt itself into a later...

I have a Briggs industrial engine. Its a 250cc 1150 series with the 3/4" shaft. I have the advantage because it's stock with a 3 inch bore. Its a great engine I love it and has pretty good power. Anyone know of any ways I can fairly cheaply have this engine spinning faster and higher ? I've got...

Well here is my build off. Gonna being restoring this grasshopper back to its glory. Gonna power it with a clone. Doing an open class build.

Up for sale is a nice set of go power type II's. They have been cleaned and new bearings installed. On the inside of the rim they do have some corrosion. 75 plus shipping.

Hey guys, I'm hoping you can point me in the right direction. I've been getting an old bike together. I got a new carb, plug on it. The motor will start up and idle fine. But does not produce any power. It won't even spin the tire on ice. It doesn't get very high rpms and really anything...

Power Products? What Model?

Hey Fellas, I have an NOS Power Products air cleaner for sale. $100 plus shipping. Thanks. :thumbsup: Exactly like the one on my Dart...

Power Products engine and early Tecumseh engine as pictured for rebuild or parts. Both for $100.00 plus shipping.

Me and my neighbor just picked up two stock DB30's... and immediately "predatorized" them:gunsmilie: Awesome old school look, with modern power. :scooter: (Mine is on the right. Seat by LXM Boutique.) Thx to great info found here on the forum , and great parts / fast shipping from the OldMiniBikes...

Go power wheels $140.00. Just the wheels sprocket is already sold.:hammer::hammer:

so i got a baja warrior last year and the engine was shit. got a new engine for it. maybe a little to big but i made it fit. now i need some ideas on how to make the bike stop without killing my self. stock brake doesn't quite work at higher speeds. the trailer is there just to give me some...

I need a good clutch for a Power Products motor. 9/16" shaft.

I am in need of a half of a 6 inch Go Power wheel. The rim is broke on one of mine and I need to replace. Thanks Gary M

unknown if runs,has great compression,showing 90lbs. what you see is what you get,engines are complete minus exhausts. these were all surplus from a heavy equipment operator who bought them from Stone company. they were in a tractor trailer,gathering dust for many years. they dont look like...

have a nice set of go powers for sale $150.00 shipped to the 48 or wheels brake and sprocket someone did a bolt over on it but still very usable $170.00 plus shipping

looking for 6" rear rim with sprocket

Does anybody know about these mini bikes. I picked up a Falcon mini bike made by Power Dyne. Not sure of the age. Its all there in good condition and runs great. It has a kick start that also works great. Thanks for any info.

Can any of you guys make a list of parts/mods to get the most low end torque out of a predator or clone? Around 3 - 4k rpm would be best. (I'm just curious because it would be cool to do on a go kart for dirt drifting)

Looking for OHH-50, 55, 60, or 65 piston rings (they are all the same, no?) stock bore or + 0.010".

I just obtained one and would like to learn more and share what I know so far . yes I have been using the search but I was hoping to share and learn more