.265 Dyno cam for trade

T

tlizard2

Member
#9
#9
Clearly the guys above are pulling your leg, so lets get serious, I'll trade you a nearly unused stock cam (about .5 hrs for break in) for it, and a very clean, low use govener gear with retaining clip and washer.:thumbsup:
 
Last edited:
Oldschool

Oldschool

New Member
#10
#10
Depending on the condition and version I would say 30 dollars would be a good place to start a negotiation from my perspective.

I think thats a pretty decent cam to be honest, but I like small cams with more durration and inspite of what many people say or think a regrind offers some advantages if you chose your parts correctly
 
Peyote_Pete

Peyote_Pete

New Member
#11
#11
Im looking to get a max torque 3/4" drive #35 clutch (35.00) I also need some 26lb springs, hp valve retainers lash caps and stainless valves. The cam is for a gx160/200 and is worth about $35-40 to me. (although the raisinettes and sawdust sounds pretty tempting, hard or softwood???):thumbsup:
 
You must log in or register to reply here.
Top