Bonanza chopper- quick question

Scottessey

Scottessey

Active Member
#1
#1
Hi Fellas, I'm helping an OldMiniBikes member with his Bonanza chopper. I'm hoping to send it out to powder coat tomorrow. Before I send it out, I want to confirm if these tabs are correct or if they've been re-welded at some point. The one on the left is horizontal, but the one on the right has about a 20 degree tilt downward. Is this correct? :shrug: Intentional?

 
bigevilone2

bigevilone2

#2
#2
There just brake cable holders. You should be alright. Really should figure out which side your gonna run the sprocket on and put the whole wheel assembly on and run the cable through the holder hook it up to the brake arm and see the alignment.

Just my opinion ! But you knew this.
Actually you should put the whole bike together and make sure everything is cool. I've seen too many people assume everything is ok and send the frame out for paint or powdercoat and get it back and something needed to be changed on the frame(like jack shaft bearing holders,the neck bolt too loose in the neck and so on)
 
You must log in or register to reply here.
Top