Having trouble at the house with my email server, so I can't load the picture I took, but here's my question.
My Baja MB165 frame rails aren't in line across the bottom. If I use a straight edge along the bottom on the motor mount area of the frame, the rear rails where the axle is attached are about 2 1/2" or 3" higher than the line of the motor mount. Is this OK? I got the bike from a bigger guy than I am so I'm just wondering it the frame is bent or tweaked, or if that's the way it was built at the factory. Thanks, tim
My Baja MB165 frame rails aren't in line across the bottom. If I use a straight edge along the bottom on the motor mount area of the frame, the rear rails where the axle is attached are about 2 1/2" or 3" higher than the line of the motor mount. Is this OK? I got the bike from a bigger guy than I am so I'm just wondering it the frame is bent or tweaked, or if that's the way it was built at the factory. Thanks, tim