NEED Linkage for H50

[riso79]

I have a H50 and the standard linkage I bought from OldMiniBikes is clearly not the correct one. I purchased part number 730136A.

I am putting back together a Stellar - George Barris Super Stocker and it did not have the correct engine. I purchased the H50 and what I thought was the correct linkage but it is not. I have the thumb throttle linkage the motor came with but I need the variable linkage. Should I replace the carb?

Any direction would be greatly appreciated.

 

[Stangrcr1]

That is the same linkage I just put on my HS50.... Works great.

It your are using solid cable, wrong.

Thumb throttle? The lever type? Need to get a set of twist for the handlebars.

 

[Stangrcr1]

This throttle setup

 

[Mark G]

That is the same linkage I just put on my HS50.... Works great.

He said his motor is a "H" 50- you have a "HS" 50...Two different engines, two different throttle set ups.

The answer needed is right at the top of the page...

http://www.oldminibikes.com/forum/t...your-h40-h70-tecumseh-big-block-throttle.html

 

[riso79]

Well, that is a lot of parts to dig up. I am down for the challenge but there isn't a kit that will do it?

Mark, thank you.

 

[Stangrcr1]

oops... Must remember to put on my glasses before reading posts...

 

[riso79]

oops... Must remember to put on my glasses before reading posts...

No Problem, I do the same thing all the time. Now help me find those parts. LOL

 

[Mark G]

Well, that is a lot of parts to dig up. I am down for the challenge but there isn't a kit that will do it?

Mark, thank you.

You might want to give Joe51 a shout:thumbsup:

http://www.oldminibikes.com/forum/tecumseh-engines/27931-tecumseh-throttle-big-block-repro-q.html

 

[riso79]

So I ordered everything but the speed control bracket today from Lawn Mower Parts

The 30199 and 30199A are no longer being made. Hopefully joe51 or Mikey Likes It can come through.