Replacing 6.5 clone crank seal without removing crankshaft

[bwt]

I need to replace the crank seal on the flywheel side. I don't mind having to remove the flywheel, but I would like to remove the old seal and put in the new one without removing the crankshaft. Is there a good way to do this?

 

[JamnJM]

You might can do it but you might also screw up that seal too.

Use an angle pick to insert into the seal & pull it out. Grease up seal lip and slide it on the crank shaft.

Tap lightly on seal or better yet find a large fender washer that fits over the crank end and use that as a seal installer to push & tap on....

Good luck buckwheat!