Search results

does any one out there know the make of this mini?

I just picked up a lil indian roller, has the large hole in the middle of the engine plate. my question is: cant find a vin or id number on it. checked the motor plate and the axel bracket. nothing. heard there was a period where they were not stamped? thanks for any info

just got an older lil indian roller, it has a 36 tooth 420 chain back sprocket. its in good cond. should I keep running that or change out to a 60 tooth or so larger?????? what would the difference be in top or bottom end???? thanks much for any info

hey Honda trail guys I have a 70 ct trail 70 4 speed that was starting on the 1st kick when I got it , now no start, pulled plug , gets spark some times, getting fuel, any ideas ???

any one out there know anything about what I would need to make a 1970 Honda trail 70 street legal in new York state? I have no title by the way. I hear you don,t need one for 1972 or before to register the bike

i have a brand new 6.5 horse 212 hf predator. i can,t seem to get this thing to idle lower, wants to take off when you start up. throttle is hooked up right , put on an extra return spring, after turning the idle screw down, nothing seems to happen. any advice out there? don,t know if i like...

need some help . just got my hf 212 6.5 on my older db 30 doodle bug. whe i put the clutch on --with set screws, and end bolt with washer, clutch got hot then hell, started smoking after a 5 -8 minute run. took out set screws -no heat - no smoke, but now it wants to engage at idle. why? did i...

need advice on how i can lower the fuel tank on a tec h50. any one make a lower mounting bracket? will this effect fuel flow if lowered, motor will not fit in my frame with out do this. thanks

how do i know what horse my older sears tecumseh is? no hp 25 or 35 0r 30 in serial # i know its sears from the 143 , any help out ther??? thanks

have a 97 cc predator engine . starts and idels nice , but when you get on it , seems to misfire and run rough. plug shot? carb clean out? also getting alot of clutch clatter

found an older model tecumseh 3 hp i believe, good spark, starts , but leaks gas from around carb bowl pretty bad while running, or not, gas line looks good , any ideas?:confused:

picked up a briggs 3 hp #80212 with no spark, no shock when turned over and holding wire, cleaned rust off fly wheel. have not cleand points yet, think coil is shot , condenser??? what next? any help would be good thanks

any one out there have pics or know how on installing a clutch basnd brake on an older on a 1960,s briggs?? thanks

i have a 2 horse or 2.5 horse briggs engine from 1965, runs if you put gas or ether in carb,pulled plug --is dry, getting spark but no fuel, dropped gas tank cleand out, tube from tank to carb looks clean any, should i rebuild carb or what???