I know it's not a mini bike, but has anyone seen an over bore kit for a 1973 Honda xl 175?
They were made by "Henry Abe'', and ''Powroll'' to the best of my knowledge.
I was saving this for a build but I bought a built gx200 so its for sale.
Model # 132232
I started it once and it sounded good. It's a 3/4 tapped and keyed pto shaft and the side cover has the four bolt bosses. Judging by the serial number it is a '92 engine. It looks very clean but I have not...
I'm looking for a 10 tooth 35 chain 3/4 bore clutch for my doodle bug. If any one just has a old worn out one i just need the sprocket really, i have pay pal or can send a money order or could trade you my 12 tooth
I have a spare flat top and the bore size is smaller than my 5hp block. What is the standard bore on the 3hp and the 4hp blocks? I also noticed the wrist pin is larger and the large end of the connecting rod is a larger diameter than my 5hp too. I did not get the original shroud with the engine...
I'm wanting to get the honda flat top piston with the +.75mm bore and was wondering if it will make that much of a difference if I go with that size. I know I'll have to get it bored and might as well get it decked. Will the bigger piston work with the STD length billet rod? And what gains can I...
I have a good aluminum bore block 5hp flathead Briggs, would that be a good candidate to build a modified motor out of? or will it wear out pretty quick?
I know that the blocks with the 2 bearing on the crank and the iron bore are better, but I am trying to determine what to do with this...
I forgot to measure before, but after, it ended up at 16.5mm lol
I drilled it, then used a lifter-bore hone. Turned out nice, for some thing I have no use for :)
What do you all do to restore an aluminum bore that is tapered or scored too bad to use.
My first thought would be to install a cast iron liner as I have literally done hundreds on motorcycle and ATV cylinders that I can bore all the way through but the typical Briggs and Tecumseh would...
What is the stock cylinder bore size on a 5hp I/C motor? I got a used block and need to have the cylinder cleaned up and bored to fit my piston, just hoping it isn't bored bigger than my piston or it's back to square one again. UGH!
looking for new or used hop up parts for the212cc predator
billet flywheel, header, and airfilter kit.
5/8 bore torque. converter w/ belt.
or 5/8 jackshaft kit for ruttman pac mule
Azusa steel sprocket hub for a one inch axle.
Perfect for a mini drag bike, or kart.
Proceeds go to Evil Ed's Windber trip 2012.
$20.00 Delivered to any of the lower 48 states.
Send me a Private Message(PM).
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.