cat99

NOTE *I made my own jackshaft a while back to replace the worn one so this isn't 100% accurate to a stock jackshaft install. * The driven and Driver are 30 Series Chinese, the belt is genuine Comet #203590A While I had the shaft out I put 1/4-20 tapped holes on the ends of the shaft ... I...

I am manly looking for a Comet cat 99 driver (engine side 3/4") assy in good shape but would also be interested in some driven parts too. could maybe use a at least a good driven outer halve with the ramps if it looks better than what I have. Figure I'll look for a week or so before I order up...

I have a heathkit hilltopper and the driven part of the torque converter is in bad shape. Can I replace the driven section of a cat99 in this bike with a 30 driven unit? I see that they are both asymmetrical. Sorry for the questions but I am new to this. I want to still use the stock covers

I have one, but it's shot, anyone have one of these? Would take a TAV30 driven too. Thanks.

I have an original complete CAT99 made by Comet available. This is a torque converter much like the TAV30's and TAV2's, but this is an earlier model that uses a 5/8" belt (still asymmetric like the TAV30 and TAV2). You can still acquire belts for these at gokartsupply.com, but I do have a belt...