I purchased a throttle linkage kit from OldMiniBikes and am curious if anyone has pictures or instructions how to install it, I can't find much of anything on the subject
So I just got the arc 1st and 3rd generation billet flywheel from OldMiniBikes and when I was installing it was rubbing on the crankcase I grinded down the studs behind the flywheel and it still grinds. Then after looking closer I noticed that the center hole where it mounts to the tapered part of the...
After reading through the "performance jackshaft" sticky - I decided to give one a go. The craftsmanship and ease of install looks awesome on the PMR unit - but that takes all of the fun of fabrication out of it...
I decided to pick up an Azusa jackshaft kit and make up some plates to...
Does anyone know of better wheel bearings for the Baja Heat/Warrior?
I want to install higher quality bearings for higher travel speeds and longer bearing life.
How do I install this puppy? Carb came with some screws / bolts... Washers...
Can,any one give me some kind,of guide to installing carb on the head.
I have everything I would need to install
Your advice is appreciated
I'll post some,pictures if I can
I purchased a Tecumseh HSK850 5 hp 2 cycle engine from a snowblower a while back. Has anyone used one of these? I plan to install a 22mm slide carb-and a custom exhaust. Thanks for any info.
collected enough parts to build a mickey bike, waiting on a seat and still have to install a few more parts and im cruising in style.
sorry i cant figure out how to post a pic yet
Been looking around and a lot of questions involving camshaft installation so why not make a thread
Step 1
Remove your engine and set it in a clear area
Step 2
Remove spark plug
Step 3
Remove engine oil drain plug
Step 4
Remove the fan shroud and starter
Step 5
Remove your valve cover...
I have an older style doodlebug and got a predator 212cc engine as a gift.
I plan on getting the adjustable plate, a new clutch to fit the shaft.
PMR Adjustable Motor Mount Kit
http://shop.hotrodminibike.com/Max-Torque-Clutch-3-4-MT455.htm
For the clutch, are people generally choosing the 12...
Got the adapter plate from OldMiniBikes and it did not come with instructions ?? Where do i need to drill the 4 holes ? Also went with a hillard clutch do i need spacers to align it correctly ? Theres about a 1/16 gap between the bolt and clutch .. 212 predator on a doodlebug
Hi again. Please refer to my other thread in this forum as to why my Baja's stock 200cc engine is not currently running... Hopefully two of my dad's mechanic friends can figure it out soon... I spoke briefly with several small engine repair shops in my area and they don't do work on clones...
I bought the 11 inch header with muffler and it didn't fit at first. has anyone had this problem? the muffler hit the frame in 2 spots, the "handle" on the back of the frame and the bar under it. i made small dents in the muffler and it went on. the flange had to be drilled quite a bit. but now...
ok, so I got the aftermarket filter kit. No problems putting it on, but now what do I do with the breather hole in the valve cover? and what do I do with the fuel tank vent tube.
Both went into the stock air box.
you can see them in the pic.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.