spark

NOS Taylor Tecumseh 200 spark arrestor. $80 shipped and it's yours. PayPal only please send as a gift or add 3%. Thanks Joe

Can you just replace the spark plug lead on Tecumseh engines or do you have to replace the whole coil? Does that lead detach on any of the coils of yesteryear anyway?

Kids eatin the Ramen...need to move some parts! This is a Powell spark arrester in excellent condition. I had it bead blasted then cleaned the bottom very well. Looking for $125 shipped...or make me an offer!

What is the proper plug gap for a lightly modified Predator 212? The manual doesn't say. I have a Hemi with a header, billet filter adaptor, Uni filter, number 90 main jet, and a .016 pilot jet. After I jetted it today, it felt soft on acceleration. I checked the gap and noticed it was smallish...

Wanting the best spark plug possible for my b&s Raptr 1. Hoping to get more spark for starting engine.

Sorry for the dumb question but I remember reading somewhere that there is a spark plug that everyone uses in the predator that is supposed to be hands down the best. I cannot seem to fine where I read this. Would anyone know wich one it is. Thanks in advance.

Hello everyone! New to the forum! I dug out my old mini bike I had. Its been sitting for years. So I have two questions about it. 1. I have no spark. No idea what to look for or even check on these little things! So any advice appreciated! 2. When I just push it around, it will go a...

Taylor Spark Arrestor Model 100 33223 Should be correct for the HS40 and can fit the HS50 just not port matched NOS but has some pits and scuffs Located in Wisconsin Paypal preferred $100.00 shipped

I 've got this little flathead to put on my first mini bike build, I got it off ebay. After I won the bid on the engine the guy called me and said it had stopped firing, and I told him that was not a problem. My question is instead of replacing the points can't I just buy a solid state coil...

why is there a resistor in my spark plug boot, and should I remove it?

I am reassembling my engine with a Honda flat top piston and running the math for interference before I seal the deal with the first rip of the cord has any one had to shim the spark plug up in the chamber to avoid hitting the piston I have .040" clearance piston to head and the spark plug...

Wtb taylor flat muffler for tecumseh h50 and hs50, with flex pipe, spark arrestor.

Hey guys....it has been a while since I've posted and since I could work on the Mini Bike. Since, I have built me a homemade engine stand so I could remove the old engine and further diagnose it and try to get it running. It should make it much easier to work on being on the "bench" rather than...

I have a Gx200 Clone that Has an aftermarket air filter and exhaust with a jetted Carb and I was wondering I have a new set of Bosch Platinum +2 Plugs laying around, and they seem reliable (as the set cost 10$ for 2)... Will this make a diff in performance or will it mess my engine up?

Hello, I have a subaru ex35d, and the problem is that after each run the spark plug goes oily. You can see oil at the piston thru the spark plug hole. The piston and rings are new. What do you thhink? May it cause the failure of the engine at top end rpms?? Thanks!

The best place I have to ride is idle land south of Dallas. Mainly native grasses and cactus, so have extreme fire danger most of the time, except just after it rains and early spring. The 97cc engine OEM muffler comes with a marginal spark arrestor (just some wire mess across the outlet...

so i bought an old mini bike with tecumseh flathead motor. I was testing it for a spark (took the plug out held it to the block and pulled on her) nothing. then i thought about it. It has a a shortening clip that goes on the spark plug. if i was touching this to the spark plug when testing would...

I'm getting a weak spark on an older Tec H60. Replaced points, condenser, coil, spark plug. Gaped points and plug. Was get no spark, but now getting a weak spark. How do I know if the flywheel magnets are weak, and /or need to be recharged ? How do the magnets get recharged ? Thank you for...

What spark plug are you running in a Gx390? I'm build a highly modified Gx390, going to have 12 to 1 compression running on 110 octane gas. I was wondering what's a good performance plug?

What causes a weak spark ? New points, condenser, coil, and plug. Point and plug are gaped correctly. My spark tester is showing a weak spark. Thanks.