If it's 41 chain, we have this #41 Chain, 10 Tooth - 3/4" - Mini Bike & Go-Kart Clutch but it's 10T driver. I've never seen an Aggie with a 41 chain but that doesn't mean there isn't one. Measure the teeth on your sprocket. 1/2" center of tooth to the center of the next tooth is #41. 3/8" is #35...
Cool :thumbsup: and your thread just reminded me to order the bearings for my Aggie wheels I am redoing......and that I will need a 41t clutch if I end up using them on something as my sprocket is 41t (off an Aggie 98) So thanks :smile:
Clutch covered, but can see chain and sprocket in the pic.
Can see my new $7 kickstand from OldMiniBikes. Lucky me, the pin fit perfectly in the original holder welded on. It hasn't had a kickstand for 30+ years.
Clutch covered, but can see chain and sprocket in the pic.
Can see my new $7 kickstand from OldMiniBikes. Lucky me, the pin fit perfectly in the original holder welded on. It hasn't had a kickstand for 30+ years.
:drool: Sweet ride!!! I did the same thing for my kickstand on mine, the spring attaches different than original but man that was nice that is fits without major rework!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.