I received another 3HP Briggs & Stratton ball bearing motor with a threaded 5/8" shaft and was wondering if I should add a keyway on the shaft.
I have used clutches on threaded shafts before but I usually just drill where the set screws will be and then tighten it down. I would rather have something a little more secure this time and I don't really want to take the engine apart if I don't have to.
I have used clutches on threaded shafts before but I usually just drill where the set screws will be and then tighten it down. I would rather have something a little more secure this time and I don't really want to take the engine apart if I don't have to.