Recent content by jakestg

No my bike is compeletly stocked and the only thing different is the engine. Is there a such thing as a false governer that is working correctly or what?

So I have a 6.5 from harbor freight and I just got it replaced yesterday with a new one cause the pull start on it broke. So far I have idled it for about 1 hour to help break it in and than I took it on a test ride.. For some reason the engine sounds like it is performing alot FASTER than...

Hello, So I ordered the Hydraulic Brake kit from hotrodminibikes a while back and sometime ago the caliper like overheated or something and its completely screw (I think). nvm.. I fixed the piston.. Aparently I just need new pads.

I tried to put my doodlebugs #35 drive sprocket on there but the holes dont match up.

Sorry but the website you supplied does not have 10TOOTH #41 Clutch Gearing. I cannot find it :(. Anyone know any other websites with decent prices? but thank you for that website, im going to favorite it.

]Ok, I know what I need now. Is there any way I can exchange the 12TOOTH #35 CHAIN gearing sprocket on my clutch to a 10TOOTH 40/41/420 without buying a whole new clutch? I heard you can switch them around if I'm correct. Thanks.

I ordered cjtminis kit and I believe the clutch he supplied was a 3/4 clutch? Im trying this engine on a gocart cause im curious. I just have a few questions. I see that the clutch sits with the gearing inward instead of out. Is it possible to turn it around for a gocart reason? Can I...

try putting your front fender backwards and it gives it more cover and the dirt wont hit your setup :D

Anyone here know any good websites that sell gocart frames that need only a engine and everything else on the frame is included but the engine? Thanks

Sent you a message about ordering a installation kit. :)

I sent you a message on this website :). Get back to me when you can.

Picked one up today :D. I got a 2 year warranty that also goes along with it.

Well now the engine runs top notch on half choke for which is ok. Also I got a question about the 6.5 HF engines.. Is the plate on the doodlebug frame easy to drill? Yes or No. Will the HF 6.5 sit right onto that plate on the doodlebug frame or does it need lift after drilling.

No one??

Ok now my engine runs on No Choke but it bogs up and down and doesent keep a steady RPM I guess..