Search results

I have a go kart that I have recently gotten working. The brake system wore itself out almost instantly. Kart weighs roughly 150 pounds plus about 80 pounds for the motor and 200-230 pounds for the largest rider. Figure the brakes need to be able to stop 500 pounds of weight minimum from at...

Got a predator 420cc engine on a kart. Moved the keyed kill switch up near the driver. Went to test the thing and the engine would not shut off with the key switch or a secondary kill switch I put on the wheel. Pretty positive I did not get the wires mixed up but to be sure I traced them back...

Building a go kart. Has a 420cc predator motor and a 1" bore 17t hilliard clutch. Went to test fire the motor and adjust the idle screw and noticed a good amount of smoke coming from the clutch. Shut it down tested again a few days later with idle lower, not smoking nearly as much and idles...

Got a go kart frame I'm throwing together and wanted to try out a bigger engine on it. Anyone got a 1" bore centrifugal clutch they are willing to part with? Send me a message with a price.

Some little bastards stole one of my DB30s from the driveway of my buddy's house. No worries I got it back, caught the moron riding it 20 minutes later. Wanted to know if anybody has or knows where I can get an ignition shut off that uses a key?

I bought this on craigslist for forty bucks. Been trying to find parts for it and figured it would help if I knew what it was. There are no markings on the bike that would identify it. I've got four pictures of it posted. Click Here

Got a GX200 Clone, has header, GX390 carb, 18LB. springs, air intake. Just added Mikuni fuel pump because engine bogged on bottom end (I figured this was due to poor fuel delivery). Engine runs fine with choke on and rides fine until you slow down to near stop and it just cuts out. I do not...

Looking for a header for a Honda GC190. The exhaust on this motor faces forward, need something that will wrap around a doodlebug frame to the rear in some way.