I am overhauling my 80202. I have to go to the .010 piston. For the size to hone the cylinder to. Do I just add .010 to the the small size cylinder bore
I bought a NOS Pulsa Jet carb on ebay and a fuel tank for my mower. Got it all together and found out the choke linkage cover bolt hole is not threaded , its not stripped out, just was never taped at the factory. Would anyone know what type of thread this would be. Probably will end up taking to...
though I like minibikes this time the question is for a mower. So is the only option for a warped fuel tank the roll pin and nylon washer(B&S repair part) or replacing the tank, are there any other options
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.