GTO guy- Attentiom

[johnf.357]

Hi there
love your video for the govenor removel,it was just what i was looking to do.

I have a few concerns that im sure u can give me guidence on.

I have a stock (blue 6.5 central machinery) clone)and I plan to remove the govenorThe cart is only for fun..

question # 1 -were can I buy the throttle kit u installed.

#2-american power sports sell a kit for $8.95 but it does not show what to do with the govenor arm??

#3- If I decided to install a billet rod,while I have the side case off,can this be done with out getting involve with all the other stuff,IE changing springs jets ect ect..
Thank you for your time,johnf.357

 

[GTO]

I didn't make a video.

Here a vid on setting up a clone throttle up front. Prepping a 196cc OHV 6.5 hp 4 cycle engine for kart racing

You will see he removes the gov by punching it out, some like to leave the stem as to not chance busting a hole in the block.

Heres a place that has throttle kits for the back end (or make your own) Affordable Go Karts - Throttle Linkage Kit & Instructions

 

[Parliament]

Where is this video about the gov removal?