Good day everyone. I am in need of a little guidance on the conversion. I have watched a few YouTube videos and have a basic understanding on how this works, but I have a few questions. I got a full wave 50 amp 1000 volt bridge rectifier to the conversion to dc. Hooked one of the wires from the stator to the AC marked side on the rectifier and the other wire coming from the stator caddy corner. These are the readings I have from the stator. One is at idle and one full throttle. I then measured the DC side and these are my readings. Again one is at idle and then full throttle. My question is how big of a led light can I put on it? I had one leftover from my grandsons go kart that's 72watts. I hooked it up and it lit up ok at full throttle, but at idle there's a lot of flickering like it's still on AC power, and it's pretty dim at idle. The stator isn't putting out much at idle so I'm wondering if that's as good as it's going to be at low rpm. I also saw something about a capacitor I could hook up, but I don't know which one to get that will help tone down the flicker. Thanks
Attachments
-
1.7 MB Views: 4
-
1.7 MB Views: 4
-
1.9 MB Views: 4
-
2 MB Views: 4