Well, I did buy a carb and intake specifically for it, and it runs well. I'll have to hit up Beekeeper to see if he'll ship that crank. I'd totally swap cranks at this point.
Someone else told me a Bravex style clutch would work, but I'd have to bolt it still, and I suspect the keyway still...
Hi all, wanted to share a pic of my Manco Thunderbird I've been building. Having a few set backs but enjoying it. Can't wait to finish it. After this photo was taken I wired up my kill switch. Still need to find/make a header for it, and find a front fender. I nicknamed it the junkyard dog. I...
My crank is not that long. The clutch slides on, and hits the side of the engine, and the section of the clutch with the keyway and slot is not on the crank. If I flip it back around it would work but the chain would not be straight at all.
I'm seriously >>.<< close to finishing my mini bike build.... but I'm hitting a fairly large snag..
So my engine is a 5hp briggs flathead and I'm using the typical centrifugal clutch but I have to flip the clutch so the sprocket is on the inside towards the engine.... so the chain lines up...
Well, the game changed a little yesterday when I was given a 5hp briggs flathead. It has a 3/4 shaft. But it won't run. I sprayed carb cleaner in it and also dropped some gas down the carb and it would fire... but not stay running. I took the carb apart and cleaned it but still won't run. It has...
Hey folks, haven't posted really since I signed up, busy life..
Anyway found a little time to work on my mini bike today, and I noticed some things I may have an issue with. Holding some folks can assist or shed some light and help me get this thing going.
First of all, finding a 5/8 shaft...
Must be the case. I can't even quote stuff. Weird.
Anyway, glad someone recognized the Crusher haha!
As far as the rust solution goes, I'll PM on how to do it.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.