Recent content by liljj

I have modded a predator 212 to drag race at my local track. Mods include fuel pump, billet flywheel, billet connecting rod +.020, mod 2 cheater cam, 18lb springs, high flow carb, air filter, aftermarket header and RLV muffler. The problem I am having now is that everytime I rev up the engine to...

The motor has no idle, I have tried adjusting the idle screw but to no avail. It is a stock head with a stock piston. Would getting a flat top piston and a high comp head make it run better on 100 octane? And the 19 tooth drive is my clutch sprocket.

I modded a predator 212 to put on my mini bike to drag race it 1/8 mile. Mods include fuel pump, billet flywheel, billet connecting rod, mod 2 cheater cam, 18lb springs, high flow carb, air filter, aftermarket header and RLV muffler. The engine is running on 100 octane racing fuel. I am running...

Ok thanks. :)

What is the best general gear ratio and clutch to get a HUGE launch for a descent price. $200 or less.

Are there any other cheaper clutches that perform close to as good? I have heard a lot of good reviews on this clutch but I don't want to spend soooooo much money. Thanks

Drag racing manual clutch, not a centfical but a true cable clutch I haven't seen these before but I am interested in putting one on my drag bike. It is a nitro 44 frame. 12 inch rear wheel base. Modded predator 212 with a .625 bored carb, mod 2 cheater cam, 18lb valve springs, billet fly...

These are some pics of my bike. :):thumbsup:

I saw this and it says it's for mini drag bikes. Anybody have any experience with these? Are they worth the money? http://www.minichopperssocal.com/MINIBIKE-MANUAL-CLUTCH.html

My rear tire is 12 inches. Anybody know what a good disc clutch is for the price? I don't want to spend any more than $200. Is the bully clutch a disk clutch?

It is a nitro 44 frame. 12 inch rear wheel base. Modded predator 212 with a .625 bored carb, mod 2 cheater cam, 18lb valve springs, billet fly wheel, billet connecting rob, and a fuel pump. Running gassoline. I don't know exactly how much it weighs but I'm guessing around 100 to 125lbs being...

I am planning on racing my bike at my local:helpsmilie::helpsmilie: 1/8 mile drag track. I have a Hillard inferno fury clutch. I want to know if it would be worth it to spend the money to buy a descent torque converter??? I need a lot of torque and a lot of speed. Any ideas?

Could I just re-jet the carb with the Mega Jet Kit from OldMiniBikes warehouse?

I built a drag bike from a nitro 44 frame. The motor is a predator 212 that I rebuilt. - DJ-114X ARC top plate/throttle hookup - 6934 ARC billet air filter adaptor - DJ-1257 Choke hold - Fuel Pump - 6877 Pulse inlet fitting - 6899 Angled air filter - 5' fuel hose - DJ-1420 Chain...

I built a drag bike from a nitro 44 frame. The motor is a predator 212 that I rebuilt. - DJ-114X ARC top plate/throttle hookup - 6934 ARC billet air filter adaptor - DJ-1257 Choke hold - Fuel Pump - 6877 Pulse inlet fitting - 6899 Angled air filter - 5' fuel hose - DJ-1420 Chain...