What did the early Taco 22 wheel bearings look like? Are the front the sheet metal ones with the 1/2 ID and a shoulder? And did the back wheel use the nicer bearing with the snap ring? Also was there a spacer between the bearings? thanks Mike.
Starting to restore a 1968 Taco 22. The frame is in bad shape, someone bent the upper tubes to fit a bigger motor, cut and raked the front end. I will try to post some pictures.
Starting to restore a 1968 Taco 22. The frame was damaged. It looks like someone cut and bent up the frame to fit a bigger motor. I have cut the bad welds and straighten the upper frame tubes. I was hoping someone can tell me what the inside measurement is between the upper and lower frame...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.