Search results

Are these supposed to have a torque converter on them? I've seen them both ways. Just wondering with the bigger tires.

Been working on this for a customer. Fought it for 3-4 days. Run but only on choke. Checked all the obvious, everything was fine. Come to find out the intake spacer plate has to be warped. Changed it from a running engine and everything works fine. Anyone know what year by chance?

I know this is old but was there a official "fixed" any where? I hate when people leave things unfinished.....

https://www.bigiron.com/Lots/1982CommuterTE3803WheelerATV Just found this maybe a commuter from the 70s or maybe a pacesetter?

Yes I do. I was trying to figure out what it was. I have an 8hp Briggs to put in it.

No shifter or shifter boot. Looks factory built to me

Square stock on the front. Supposed to have a fuel tank on the back bone

I haven't seen anything this big before or with that type of rear end

I seen that, but wasn't sure he was doing anymore

Thanks man I appreciate it

So is it a bird or a foremost?

Looking for a repo or a decent stock rear scrub brake. Like this

Dang, looks right on spot. My front fork is bent a little but I can fix it, yes I can! Lol Any idea on a year?......NVM. needed to look closer before I posted.

Last one from the pile. What is it?

So do I sparkwizard. I just haven't done it yet.

So it is for a scrub brake?

I was thinking maybe it was a jack shaft plate

Funky bolt on handlebars

Dug another one out. What is it?

Best picture I have at the moment. I will get better ones tomorrow. So if no heat, any other suggestions? Also the forks on the bottom look exactly like mine.it has the same hole as mine in the side behind the badge plate