Search results

Does anybody live in Minnesota and know of a place where I can ride my mini bike? I'm located in Bloomington so a 4 hour drive up north dosent really help me.

So I just got this go cart and It has a diferential in it but needs a sprocket. The bolt patterned is not like any other sprocket it's like a set of two holes close to each other on each each side of the dif ( top and bottom) so if any one knows what I'm talking about I would like to know where...

Has anybody put a snow plow on a mini bike? If you think about it it would attach to the bike just like a 3 wheeler plow would. It might be kind of stupid and not even work that good but I don't care I'm going to make one for 6.5 horse manco thunder bird and was wondering if anybody has tips

Hey guys so here's my problem I'm was trying to get my sprocket center because it bobs up and down. After looking at it more I found that the hole wheel is doing it. I don't know how to fix it. Could it be bad bearings? Bent axle? What do you think?

Hey guys I just finished my mini bike build and the problem is I have no where to ride it. I live in Bloomington MN and it illegal to ride on the streets so I just ride it up and down the street hoping a cop don't pull through. :) so where do u ride? Any body live in the same general area as me...

So I have a honda gx140 and the problem is when I try to rev it some times it will rev up but that is rare it usually just kills but it will idle. It idle up and down also. Could it be lack of compression?

So I got a Honda GX 140 off of craigslist and the guy said it didn't run (so I got it for cheep) so I sprayed some starting fluid in it and it ran but when I tried to get it to run on gas nothing happens. I will only run on starting fluid. what do you think I should do? another question...

All right guys I kind of new to this but on my project, the gas tank sits level with the carb and the fuel line comes out of the bottom of the tank. so that mean the gas has to flow up to the cab. Will that work or does the tank have to be above the carb so the gas will flow down to it...