Hello,
I am looking into a laser chain alignment tool. They seem to be kinda pricey for what they are. Does anyone make something that you can just attach a laser pointer to? That would seem to be the cheaper way to go. I don't feel like spending 90 bucks on one of these. For that matter, do...
2 laser cut cut triple tree plates. 3/16" thick. 5/8" hole for neck bolt. 1" holes for fork tubes. 12" center to center for fork down tubes. I had 4 made. Only need 2. $30 shipped from Grandville mi. I can text photos. Or email.
I know LSCustoms has been cutting parts out of metal from some posts and discussions, are you using waterjet or laser? I have a buddy here in Ohio that is looking into this trying to figure out what would best suit him, what would you recommend? He will making brush guards, pipe bumpers, plate...
sent eric some used mcculloch gaskets to have him reproduced.
got some samples in the mail today.
still need to send a shroud to block and a large bore carb setup gaskets to him
:bowdown: :bowdown: :bowdown: :bowdown: :bowdown:
coming soon to a store near you
A buddy just bought a second cutter that will do up to 1 inch thick, I am bored of cutting my name in stuff and I get free waste space so what should I make??
stainless motor plates?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.