placement

Hello, total novice here. Can somebody please tell me how to set up throttle wire on this carb? where to feed wire and with what parts? I have used search a few times for help, I see pictures of various engines and hook ups but I guess I need a visual or specific instruction for this carb. I...

I know I've seen it done here but can't locate the threads. I need to reconfigure a Model 30 TC so that the driven sprocket is on the inboard side of the backplate. Short of obtaining a new 5/8 shaft, what else is involved?

im looking to id my bonanza mini bike. but idk where the id# is. please help

Hey guys, I am in the process of restoring an old mini bike I have. I am basically replacing everything but the frame. I purchased a predator 212 engine and it fits in the frame, but it sits off to the right side a lot more than I expected. The right foot peg, which is just a little 6" bar...

Hi there, are there any Taco veterans out there. Im almost finsihed restoring my 1968 Taco 99. Can't seem to remember where the correct kick stand spring mounting place was.

I need some ideas on how I can attack foot pegs on my Cheeftah frame to where they are lower than where the peg tube is on the frame so it gives me more knee room around the handle bars. I have a couple ideas but I want to see what some of you think I might could do. The problem I think I'm...

So I'm wanting to weld in a kickstand on my project but the problem is....I don't have the wheels or tires yet. I wanted to get all the welding done and get this frame off to powdercoat but didn't want to place my "big parts order" which includes wheels and tires until after Christmas...

Does any one no how much of the seat hangs over the rear bar under the seat.

I need some help with measurements for an engine plate for an unfortunate cr400 I got! I only want to do it once and do it right! Some butcher with no common sense hacked the original one off and installed what can be best described as a piece of scrap metal in its place! Any help with specs...