Dingo n a homebuilt kart

[Axx3d]

I have been keeping my eyes out for a kart or 2.. These popped up on CL and i scooped the pair for a deal. They both need some tlcbut i'll get them rolling soon enough.

Black one is a Dingo and the red one is a super sturdy home built.

 

[incogrhino]

Stab a predator on em and go.....:thumbsup:

 

[OND]

Nice Find . :thumbsup: Have Fun ! :smile:

 

[incogrhino]

My dingo goes 37mph with a 212cc.:thumbsup:

 

[trj1234]

Cool karts, good luck on builds

 

[Axx3d]

Thanks folx!

I plan on throwing a couple of 8hp on them n getting them going.

As with my 3 mini bikes ill go through them this winter when the snow flies. For now its summer and time to enjoy these toys!!

So the comet tc clutches will fit these?

http://www.harborfreight.com/8-hp-301cc-ohv-horizontal-shaft-gas-engine-epacarb-61563.html

Thanks for the help guys!!

 

[Harleys Papa]

So the comet tc clutches will fit these?

8 HP (301cc) OHV Horizontal Shaft Gas Engine EPA/CARB

As long as they are 1 inch drivers :thumbsup:

 

[Boomstick]

Oooo... both of those would be bitchin' with 420's & TAV's.

 

[deejaaa]

i would spend the xtra $100 and use one of these:
13 HP (420cc) OHV Horizontal Shaft Gas Engine EPA
13 HP (420cc) OHV Horizontal Shaft Gas Engine EPA
i'm not sure what the diff between the 2 are.
it would be like adding an xtra 5 hp on for a spare. 20# diff also.

 

[Axx3d]

The comets are 1". They both have the TAV setups ready to rock and good #420 chain and sprockets on both look solid. Going to buy new belts and buttons and do it right.

Good call on the 13hp.. especially with %25 off..

My list is getting longer and longer for these 2.. hahahaa.. it'll be worth it to have them mechanically sound though.

Ill work on the cosmetic aspect when its -20 and 4' of snow..

 

[incogrhino]

I had to pull the gas tank off my 212 to get it to fit. Seat back is in the way.

 

[Axx3d]

just grabbed a cple of the 8s.

rollin

 

[Axx3d]

Also.....just a guess on my part. ....but it could be because of the low oil sensor? ????

Has nothing to do with my post.. but ill make sure to future read it..

So.. i ended up ordering $300 worth of gear/belts n bolts for both karts between here and there..

ill post my exact center measurements for the next individual..

for now.. My ponies..

/

See the dingo in the back.. all been gutted and replaced with stainless hardware n ready to roll...

RedDawg is getting a complete bearing/brake/bolt/lube job overhaul.......

The CC's show uo just in time.

 

[JKautoFab]

why you think red one is homebuilt? looks like a factory built kart to me...

 

[Axx3d]

why you think red one is homebuilt? looks like a factory built kart to me...

Was told from the guy i bought the pair from.. He said that a farmer bought the Dingo then decided he could build his own, granted he copied the dingo to a T.. And it is two to three times the weight and sturdy as heck!!