Muffler Mani

[Bighomedog11]

Hey I am looking for just the muffler end part that i put the bollts threw. I am trying to make a custom pipe and i need a mani to weld the pipe onto so i can bolt it down on my Engine.
If anybody has some old pipes laying around and can cutt just the muffler part where the bolts go let me know! I just need the manifold part.

 

[5 Horse Fan]

What type of engine?

 

[Bighomedog11]

What type of engine?

For a 6.5hp Clone

 

[guardrail dave]

yrace the gasket on a piece of 3/16's steel and cut one out

 

[Bighomedog11]

I was thinking about doing that. But would that be hard to do?
Cutting steel

 

[guardrail dave]

no not really with a vise a hack saw a file and a drill about 1 hour to do /20 mins if you have a cut off wheel on a 4 '' grinder

 

[supernova]

I was thinking about doing that. But would that be hard to do?
Cutting steel

If you're not sure just buy a flange from AGK, there are several suppliers for them just type in clone exhaust flange into any search engine and you'll find one for very little coin!:thumbsup:

 

[Bighomedog11]

If you're not sure just buy a flange from AGK, there are several suppliers for them just type in clone exhaust flange into any search engine and you'll find one for very little coin!:thumbsup:

Yeah i just type that in and found one for like 8 buxs and like 6 to ship.. To much just for that..


But i do have a grinder with a 4" wheel on it

 

[C9H13NO3]

I might have one. Let me check and i'll PM you if I Do.

 

[Bighomedog11]

I might have one. Let me check and i'll PM you if I Do.

Sounds good

 

[supernova]

Brute power pipes sells em on Ebay but has a website, they have a cool do it yourself kit with everything you'd need and more.:thumbsup:

 

[mmisterbungl]

take your stock muffler and cut the pipe off flush at the flange?

 

[Bighomedog11]

take your stock muffler and cut the pipe off flush at the flange?

Yeah i was going to do that, but i was thinking if i want to put back on my stock muffler i am going to be screwed. Well i guess i wont be screwd because i could grind the weld off and attach is back if i needed too.