Does anyone know the distance from the axle centre to the fixed mounting hole? Also, about the cable goes into a pin fixing on the further end which is pulled: Is there anything I could use/make to do the job of the little pin with the grub screw, without having to buy one? I am in the UK you...
Maybe this has been gone over before, Just thought this might help someone out. For solid rims, I put a large punch or other suitable object in the vice and set the tire rim down over it. A vice grip on the bottom of the rim against the vice somehow will keep the rim from turning, while a vice...
my mini bike build is going pretty good but i was wondering if i should mount the motor straight to the frame or leave the rubber things on the motor then mount it. theres some thick rubber washers that my motor came with and i have it mounted with the rubber things right now but im thinking...
I have an old ARCO mini with an equally old 4 hp Tecumseh engine. The clutch is mounted with the sproket side towards the engine. Is this normal or backwards? Most clutches I have seen have the sproket on the outside.
I am buying a new clutch because mine engages while the bike is...
I have A tec big block with the shroud hanging below the bottom of the block and bolts are narrower than any of my frame holes. Is there an adapter plate to bolt on that would lift it up and fit the mount holes? i can get some pics tonight.
My method has always traditionally been to drill a series of adjacent overlapping holes, then clean it up with a hand-held jig saw with metal-cutting blade and finally a file.:grind: I would describe the end result as mediocre at best, and I am looking for more professional result:shrug: How...
It has been about 40 years since I had a mini bike, so forgive my ignorance. It seems like the key way on the clutch and crank shaft should line up, but mine does not. There are two 'bumps' inside the clutch that keep it from going on the way I think it should. Question: Should I file those...
I need one for an HS50. I assume an HS40 would fit it too, and possibly others. Looking for a black or graphite colored one, hopefully in good shape with little to no rust.
I also need two oil fill caps....one will do, but two would be fantastic.
Like this one....but i just need the main...
Does anyone out there have a photo or diagram on how the 6 volt battery was mounted under the seat? As well as if they came with a battery box or not. Thank you
I am starting this as a new thread in an effort to receive more replies, as my question became buried in another thread.....
Who out there has added an additional mounting plate to the original to strengthen/reinforce it due to installing a larger engine? Where do you buy the plate stock and...
The one on my mini looks like Swiss cheese. How many holes and slots in the mounting plate before it compromises the strength and its time to replace? Do you just bolt or weld another one on top of the original one? Mine has the original slotted set, another slotted set, and (now) another set of...
I got my new tires yesterday for my rupp sprint with 6" turbine wheels but I ran into problems because the tires were all distorted and each center was way off from the other side .
For those of you that are not familiar with rupp front wheels they are made up of three pieces 2 rims and a...
Hey guys, some people have said that in order to mount your sprocket right, you need what's called a "sprocket holder hub". I've seen one on Amazon and they look alright, but I was thinking I could just take the sprocket and weld on a really wide piece of iron pipe and then weld that to...
So, tonight I was pulling the old tires off my rims in preparation for blast/powdercoating and as I'm prying and tearing with 3 different pry bars for 15 minutes each I got to thinking how in the heck am I going to get the new tires back on? These are one piece sears minibike wheels. Any...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.