I got a Doodle Bug with the 6.5 horse upgrade.Keeps throwin the chain.It has a small steel strip with a pulley bolted to the frame that you move to adjust tension.Theres no motor adjustment(fixed hole).You just loosen the bolt and move the bracket/pulley to adjust tension.B.S. :hammer:Anyone...
basically my engine keeps failing when i go to warm it up the video explains it all. but i personally think it is because its really cold out but, just watch and see
YouTube - doodlebug prblem
i have the 6.5 upgrade, it ran good with the gov in and it runs great with it out but if i dont have the throttle just cracked a little while sitting still it wants to shut off. even while it being hot. i dont know if it is a throttle adjustment i need to do or if the carb is to rich. what is...
i have been having trouble posting pics am a member of other forums very similar to this one and had no trouble there what am i doing wrong i have alot of pics to share and cannot please help
I want to put a briggs 5 hp on a mini bike but I want to do away with the tank and use the one on the frame What carb can I use. Will one from a verticle shaft work or does any one know of one I can use.Thanks
well baja sent me 2 pull starters and a new gas tank under warrnaty...
My problem is that it will not start.. It will start by shooting carb cleaner in carb but only run for a few seconds. I took the carb off and blew out the insides and jets, replaced rusted gas tank with all new and new...
it seemes that all my tecumseh carbs all dont work. i dont know if it is me or not. i start up the bike and it will only run if is spray starter fluid in it. it will stare then shut off. it looks to me that the fuel bowl is not filling up. i have a dozen carbs or so and none of them seem to...
Well, I finally started the engine on the MTD build tonight. I can't seem to get the idle lowered though. I checked the slide on the Mikuni and it's bottomed out as it should be. The idle screw is turned out as far as it would go without completely falling out of the carb. It's idliing so high...
Whenever I try to load a picture into my photo album it tells me that I've "uploaded pictures sucessfully" but then when I go to have a look its says I haven't loaded any pics
ive tried this from multple computers (with cookies enabled) to no avail! :sadcrying4:
any help would be great...
My bike has 4 hp tecumseh in it. My problem is that it keeps shearing off the keyway that holds crank pulley in place so after a couple of tugs its done. HELP please
I have a hs50 tecumseh with intermittant spark. I want to replace the points and condensor with electronic ignition. Do they make these for a tecumseh and where can I get one? Also how do I check the coil. Thanks John
hey guys its me again ok so i have a 60s briggs 5 hp ok im not getting any spark. i check the plug is good mag i no works so i kinda narrowed it down to the on and off switch and the wire that goes the to points the points look in ok shape now my ?is how can i check if the switch is...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.