Recent content by BradD

I will do the chassis satin black and the tank, rear fender, and some engine tins in a dark olive green metallic

I finally received and finished my bobber just in time for the Detroit Autorama and had it on display in the basement. I rode it this has Wednesday before move in day and rode it on the roof of cobo hall after the show ended Sunday. Next will be to finish the little bit of fab needed then...

I will be building a long frame Ruttman for this seasons shows and to play around on. The bike will have new tabs to stretch and lower it and be sitting on the new 4 spoke studz racing mags that are styled after the original 4 spoke mag wheels. Wrapped in a old school 410x3.50-6 square rear...

Yes I am looking for a steel tank

I’m just looking for that style tank, briggs or Tecumseh would be fine as long as condition is good and it’s similar.

Does the tank have any dents or dings? Would you sell just the tank And brackets.

Is the tank still available? How’s the inside?

What’s the condition of the steel tank on the Tecumseh and what are the dimensions?

What’s the dimensions and how’s the inside look?

Set it on the ground today. Liking the way it looks.

Got the tabs on the forks. Just waiting on neck bushings, front axle and nut, and new front tire. its sits just under 2” off the ground

I’ve seen them bad too. Wheel barrel quality and youd loose half the load by time ya go there your headed lol.

When I spun this one it seems to be pretty good. I didn’t put a dial indicator on it. I used it for moch up and if future owner wants something more true I always recommend a Douglas kart style wheel.

I may end up putting the front at 1.5” to match the rear. I did not change the tube angle but will add stabilizer mounts so if the future owner wants to add one it will bolt right on. I am getting ready to do a long frame ruttman next. That will be 2” clearance.

I recently picked up an Azusa frame for a great deal. They are far from my favorite but since I picked it up so cheap I figured I’d try to modify it to show off a new venture of mini bike fab I went for. I had new axle tabs laser cut with BSE(Brads Small Engines logo) in them with disc brake...