Recent content by Drewman79

Price drop need this gone! -$65.00 shipped to the lower 48. Bump!!!

112-ALT ( Cast Welded Lobe) Made by dyno cams -Cam is currently in a Briggs Flathead 4.500 long rod stroker on a minibike. Has been run very little, if pictures are needed I can pull it and snap a few. Below is the link to the cam card. Any questions feel free to ask! Thank you! Cam Card...

Thanks man! and im just waiting on a arc flywheel and ill fire it up...but i ran that pipe on another flathead and its sounds absolutely bad ass!:thumbsup:

Thanks man! A really good buddy of mine made the intake/exhaust....its a dual bearing 4.5 long rod stroker... engine work is all done by me.

FLATHEADS FOREVER:gunsmilie:

Your can run the gas pipe...just remember its heavy and if it becomes loose and moves around it will bust out the threads in the block so make sure its tight..or use a jam nut.:thumbsup:

Im in...:evil_laughter:

Im prity sure Ruttman had the lip on the edge of the rim...and also they are thinner were the bearing is so a hat gear can be put on the rim.

Go to your local small engine shop and buy the new style coil or go online....the kit comes with everything u need to convert to CDI and plug the hole. its very simple to install and a new coil is always a plus. -Andrew

Man i wish u were closer! if u part out the engine id be intereted in the pull start cover... Good luck with your sale!:thumbsup:

Nice work man

Bike looks great man! you did a great job...needs a Flathead Briggs thoght.. :thumbsup:

Welcome to the site! sweet bikes! i love that red seat:thumbsup:

SOOOOOOOOOOOOOOOOOO Badass!! awsome build man! :thumbsup:

updates! enjoy!