I think my issue is for sure the roller not spinning freely, may I ask what the roller wheel is rotating around, a bolt, axle, etc. My setup is pretty meh just thrown together, the spring is definitely too tight as well.
Those look really nice but definitely way out of budget. That would add up to be 1/4 of my minibikes worth if I used that. Do you know of any cheaper ones? If not I’ll just try to reconfigure mine with a trailing arm. The whole setup is pretty meh and was thrown together quickly. But it got the...
So i’ve thrown together a pretty strange setup for my chain tensioner on my minibike. The issue i’m running into however is that the chain is completely destroying the roller wheel. I’ve had on wheel get completely eaten all the way to the bearing and now caused a chain to break. My question is...
I’m assuming you’re referring to rod bearings? Because I haven’t heard a single knock from this thing. If it is spinning i’d be glad to replace the rod anyways.
I thought about that but the stage 1 really shouldn’t be pulling enough fuel that the stock carb can’t handle it. It’s only got an intake and header. Now if i were to do cams and valve springs then I would for sure think the mikuni is necessary
This thing has left me on the side of the road too. Also do you have any ideas on why it feels like it’s topping over as it revs out. I feel like it has more in it but maybe i’m just doing as much as the valves can handle.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.