Recent content by rivetrider

Yes, it certainly does, thx

This was my deceased brothers, looking for info, tia

Made this to go to events at Mid Ohio race track. Carries a small cooler and lawn chair. Assembly is self explanatory. Harbor Freight 90 flux core welder Basic hand tools Flat steel needed: 2-1/8x1x4 1/2 2-1/8x1x10 1-1/8x1 32(formed to fit) 5/32 welding rod for crossbars 2- conduit clamps 1 inch

Military Theme

Bought a Cub Cadet snow blower over the winter (best single stage cub cadet offers)has a headlight on it and motor is like a predator if someone could get a part number for this coil I think this coil could be used on a predator just throwin this out there i have owners manual but im not...

hotrodminibike.com

1/8 by 1 x1 angle,5/32 welding rods with flux knocked off,2pcs 1/8 by 3/4 x7 2 3/4 u clamps welded it all together (welding rods are the crossbars in rack)

built the doodle thug in 2011 been working on this since last fall rack is for cooler and lawn chair at mid ohio racetrack stock engine,header, spring loaded chain tensioner,custom built clutch guard

Bought this the other day. My guess is a 60's Bird. Like I say leave it to the experts.Thanks for any input.

Had to have a spacer made for this setup, got brake and sprocket with wheel.Brake is foot operated. Best brake ive ever had on a mini.

Rides straight and true,might have to put your foot down on a sharp turn.

I leave my Predators stock,start easy run great.

My 3rd predator build,60's CAT. All 3 stock no header,air filter,put in ngk plug. Run great for $100

Ya,now that I think about it I should have put this in (what is it?) Bought it last week with a sick 5hp Briggs,slapped a Predator clone on it. Briggs needs carb attention and does not smoke runs well but surges a little bit vacuum leak in intake system,tank is very clean.Will repair and put...

Cat? What year? Got a chain guide on motor plate. Set up from factory with drum brake(bracket on frame) Thanks in advance for all replies!