Search results

holy f-ing s**t that was amazing

we need to set a date and place for this already.

I my carb bolts up to a round port as far as I remember. I'll look later and post some pics

yellow hand the intake on the GC isn't square

No, you can buy those engine directly from Honda. I'm running one, and it's decently fast.

Would any of these work for the GC160? one two three

bring up my post

How would I advance the ignition timing? Can I advance the cam safely? sry about the thread revival.

How exactly do you take off the gov? I'm gonna try to make an exhaust out of copper.

How exactly did that happen???

Yeah I like my Honda, its very torquey, it just is disappointing that there are very few parts for them, I'm thinking about getting a GX or Briggs.

Now we're official. lol. Just give me a date and place so I can update it and I'll start handing them out around here.

I'll talk to my uncle and go check the place but I've been riding at this one abandoned construction site that he found that a bunch of people ride.

Where in Ohio will you be? I live in a smaller town in the Akron/Canton area, but I could get a meet/run together around here.

I've seen the mini moto/ cannonball runs in other states I was wondering if they talk to the police before hand or try to out run them? But we need to get one together in like May or June. -Lightning

Is it possible to use copper pipe and solder it together? I was wonder because my uncle is a plumber and I can get some from him. Thanks, Lightning :ph34r:

I think it would be sweet to say my mini has a stroker.

Is it possible to switch a GX series crank into a GC series? Thanks, lightning

heres the link I couldn't get the vid to work right

No clue, but looks like it has some potential.