I have an old up draft Flo Jet carb from a 3 h.p. Briggs horizontal shaft engine with a broken plastic choke lever. Would anyone have a way to look up this part #? Thanks in advance for any help, John.
I have 2 of those engines, not running but both are mostly complete. One has a recoil housing and the other has the pulley to wrap the rope around it to spin it over. I have had them for many years on a shelf. Would like to find a good home for them, I will not throw them away, John.
I have a Tecumseh 6 h.p. engine and the rod to the governer is broken. Went to the local lawnmower shop and the rod was not in the picture for some reason. The numbers on the housing are 143-626 252 serial # 4151D. It is a horizontal 6 h.p. , can anyone help with a part # ? The engine is on an...
I think Stellar minibike also, has the motor plate that kicks up at the rear to support the rear fender. I had one a while back and mounted a Briggs flathead 5 h.p. on it. There is a pic of it on the Minidoodle web site, John.
Thanks for the info on the chain, I would rather spend a few extra dollars for a good chain. The chain I have been using stretches out too quickly. I figure that a better quality chain will increase the life of the teeth on the sprocket as well. Thanks again, John.
Guy I work with brought me the January 2008 magazine The Horse. Check out pages 86-87...cool write up on a minibike race at a hotel somewhere with some funny pictures. The website is THEHORSEBC.COM . Check it out for some good reading and pictures, John.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.