I have a PMR Jackshaft and a Briggs & Stratton engine pictured below. The bolt pattern on the PMR doesnt match the value cover on the engine. Even the center hole on the PMR is to small for the small outlay near the shaft. I can easily expand out with a drill press but I am wondering about...
Hey first post!
I am trying to restore this mini bike I played with as a kid. The only things I added were the sissy bar and gas/drink rack in the back (see red arrows). I also added the two rear foot pegs.
This is a large mini bike compared to some that look like it and are much...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.