Search results

Looking for a pair of original taco rear shocks for a '67 taco 44 restoration project. Thanks, Tom

1967 Taco 44. What is the correct Cherry Brake Lever. One picture is a riveted lever with the handle bar bolts threaded into the lever (no nuts). It also has a circled R stamped into the bracket. The other picture is an original 1967 Taco 44. All using nuts and bolts. Is the riveted...

The swing arms were badly dished from nuts. It was suggested to use brass bushings, 1/2 od, 3/8 id. Should I do both the swing arms and frame? Flanged bushings? Nylon washers between the arms and frame? Any help before the powder coating is appreciated. Also, notice the original purple taco...

Hi OldMiniBikes'ers, Does anybody know the original/stock jackshaft, clutch, and rear sprocket gearing for a 1967 Taco 44. 3hp B&S. It did come to me with an 11 sprocket clutch, 16 and 11 on the jackshaft, and a 60 back wheel sprocket. The clutch sprocket and rear wheel are in good shape. But, the...

Looking for a 1967 3hp B&S for a Taco 44. Running, or not. Thanks, Tom I have a 1972, front gas tank, 3hp for sale or trade. Thanks..

Me Bad:hammer:. I placed a question thread in the project log forum and need to move it to the general minibike forum. I've searched all over and havn't been able to figure it out, or if it's possible. Thank You.

Is this 1967 Taco 44 brake drum, levers, plate, and everything pictured worth restoring? Is this how John Steen manufactured this unit? I see the repos have the bolts through the drum, not welded on. How does the brake cable attach. What is missing? Thank You all for your help!!!

’67 Taco 44. What can/should I do regarding these swing arms? The questions I have are: 1. The axel bolt slot is not parallel. Should it be? Should I heat it up and try to bend the opening parallel? 2. Has anyone made some sort of bushing or is the bolts without anything sufficient? 3...

Rebuilding an old max torque clutch. It had lots of rust, which I wire wheeled off. The bushings seem to be good, no slop. What can I, should I, paint, grease, or any other recomendations for this clutch. Thank You!!!!

Looking for a project for grandpa(me) / grandson. I found this 1967 Taco 44 project. the only frame repair is the right foot peg. The seller collects, trades, and sells. He wants $350 fort this roller and includes an older, non original 3 hp B&S. The left fork handle has a slight bend with a...