Search results

Yeah,I didn't think it would allow 8k rpm (well, maybe once),but might give a small safety margin for short bursts to 6k.although, I'm not willing to be test pilot#1.

Does anyone have any experience with this? I was thinking that it would be a good way to strengthen flywheel and rod for engines that have no aftermarket parts. Maybe it could be used to safely get a couple thousand rpms from a engine.It doesn't look to be cost prohibitive considering the...

Wow,that's a nice one.If I knew when I was gonna be in OKC I would go get it.That is pretty much what I am looking for.

Chipper,thank you for the kind offer.I drive an 18 Wheeler, and will be out of town for a couple more weeks. Yeah,buckeye,I'll be 57 in February. Damn,where did all time go....you raise a good point,after 2million + miles in a truck, something to smooth out the bumps will be needed.Okay,plan...

Thanks for the welcome everyone. Unfortunately, there are no K-MART stores in TX.Elsewhere on this site I saw Motovox advertising rollers,and that is what I am looking for. I was going to put a 3hp on one and a6.5 on the other.If I have to buy new bikes and pull the new engines and sell them I...

Yeah,that's exactly what I am thinking.

Thanks,Tippicanoem,I'm kinda afraid of that.they do take up a lot less room than old cars and trucks,so maybe mama won't raise so much sand about them.:evil_laughter:

Hi,everyone. I Have been lurking for a few weeks, and checking things out. I like what y'all do here.Back in the 60's I wanted a mini so badly I couldn't stand it.So,nearly 50 years later I decided to do something about it.I don't have one yet but I'm looking. Maybe a mbx11roller (well 2, one...