I have a knock off tav2 and the center to center measures 6 3/4". The 203589a belt is for 6 5/8" - 6 11/16" and the manco 5959 Is for 6 15/16" - 7". I'm right in the middle of both of these, what should I use?? The driven clutch is centered to the backing plate.
Any ideas?
I'm looking for a rear sprocket in 72 or 60 tooth with a 5" internal drum with 6x3 1/4" hole pattern straight across. All I can find is 4 1/2 drum and the wrong bolt pattern.
https://youtu.be/s8jki2rdJMo
Hi everyone, I had my plug out, finding tdc and I noticed a clunk clink noise when turned over by hand. It happens throughout all different stages of the piston stroke. The engine runs fine and no loss of power.
The engine has been built by one of the members on...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.