Search results

Yes, I am in high school, I also tend to have a lot of homework, so if you are interested in something of mine, you can still send me a pm, it just may take a few days to get back to you.

Yes it is, if your interested shoot me a pm with any questions

Bump, $150??? Make me an offer on it

Bump $175, taking up space in the shop. Take it home and make room for another in my shop!

I have my Tecumseh OHV power sports 6.0 Hp motor up for sale, which I did have posted previously in a lot of tecumsehs. This is the last remainder of them. It does run (or did before I took the gas out) although a little rich at that and I did put a brand new Chinese carb on it. It isn't really...

Bump, Would like to see it go to a new home, Make me an offer

Thanks

Here's the picture, sorry for the delay

I am now selling my clone motor from a baja warrior that has been collecting dust for a while now. When I had it running last, it didn't smoke and had no issues. However the previous owner welded the clutch on the jackshaft assembly to the crank of the engine. That's the main reason I just...

I now have my cat 300x for sale as a roller as I mostly finished it. The paint is not the best but it was my first mini paint job, so.... Also, the motor plate is a bit scraped up because I did have a motor in it briefly. It comes with the original rear fender that still needs prepped and...

I just cleared it out, can you try and re send it now

Sale pending on silver hs40

$25 obo takes it all, need to clean out the shed

I have 2 other tecumseh motors on here, and I am putting both of those in this ad with 2 others I decided to get rid of. To start us off, I have the red Tecumseh hs40- 1 inch diameter slotted, drilled and tapped, normal length, ran with carb that's on it, just needs a choke lever, nothing else...

Thanks, I just updated it with a price and a location:thumbsup:

Next up is my good running Tecumseh h35 engine. I believe this motor came off a snow blower or a tiller as it has a tag on the side that says craftsman. I put a brand new carb on it last year and had it in a minibike until I sold it as a roller. The shaft is standard length, keyed but not...

Up for sale, I have relisted my Briggs and Stratton flat head engine parts. I have a ton of stuff for the 5hp motors, 2 carbs, 2 tanks, 3 sets of points, the list goes on. I bought a new set of rings which I already installed on my nicest piston and I also have a new set of gaskets I will...

New price- $30 obo takes it, local pickup only in Monroeville pa Thanks for looking, Ty

The shaft is tapped if that’s what you mean, it has a key way and is i believe 2 1/4 long

I’ll have to look into that, thanks