Someone local to me is selling this, is it a taco 22? Or Temecula bob? And also can the frame be saved? I don’t care about the bars or engine since there not original. I mainly want the frame
Someone local to me is selling this, is it a taco 22? Or Temecula bob? And also can the frame be saved? I don’t care about the bars or engine since there not original. I mainly want the frame
Hello, I have a Briggs flathead that I would like to convert to gas for a mini bike I have, I had bought this engine and a few other engines and parts from an estate sell. so I don’t really know much about the engine,it looks to be open modified to me but idk. I believe it ran on alky before...
Hey I have this tire and tube off a mini bike, it’s only 1 tire and is in good condition. It was holding air when take off the rim and still has plenty of tread life, Shoot me a offer if interested. Thanks
Hello, just recently I had bought a few Briggs flathead engines that look to be built modified engines that are complete. They have been sitting far about a year from what I’ve been told, My question is how can I find out what fuel these engines were ran with? They all have tillotson like...
Hello, I’m currently building a 212 non hemi and have ran into some issues with my piston to Valve clearance.. I aligned the cam dots and put the side cover on, put in my pushrods and spun the engine over and my piston is hitting the valves, I personally think my pushrods are way too long (...
Hello, I will be installing 26lbs springs in a non hemi predator and would like to know how can I measure the spring install height without any special tools? Thanks
Hello, I will be installing 26lbs springs in a non hemi predator and would like to know how can I measure the spring install height without any special tools? Thanks
Hello, I’m building a predator 212 non hemi and need advice on achieving a 10.5 to 1 compression ratio, how much should I shave the head? I haven’t measured how deep the piston is in the hole yet because I already took the whole engine apart and I’m waiting on my ring compressor and other parts...
Hello, I’m building a predator 212 non hemi and need advice on achieving a 10.5 to 1 compression ratio, how much should I shave the head? I haven’t measured how deep the piston is in the hole yet because I already took the whole engine apart and I’m waiting on my ring compressor and other parts...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.