disassemble

I can see how the springs fit into the bottom cup of the sissy bar and the top cup of the lower section that attaches to the frame. The cups are notched. To dissemble it looks like you have to twist the bottom piece to basically unscrew it. Is that how it works? Any tricks, secrets or...

I'm working on restoring a Fox Spoiler from the '70's era. I've owned it since I was a kid. I thought it was long gone until I went through an old family shed with old lawn equipment. Surprisingly it is restorable, with the possible exception of the spoke wheels. I have wheels that will work in...

What is the process for disassembling the forks in arctic cat minis? I have a 72 prowler and the forks are very tight. I want to disassemble them and possibly put new liners in. I know there is a spring in there and one bolt at the top of the tube but I'm not sure how that comes apart. A buddy...

Looking to disassemble the 40 Series TAV driven pulley that came with my Super Bronc so that it can get a nice evaporust bath. Looks like there is a cast aluminum piece that is just screwed onto a central shaft. Do I use a strap wrench to unscrew this part? The spring is a torsion spring...

Have a 68 Rupp Continental and I want to disassemble the front forks to clean them up and the rear shocks. I don't want to screw them up. Any photos or instructions to do this right?

I have 2 sets of taco forks i am trying to disassemble so i can clean them up and repaint them. They are the upper spring style forks. i have twisted the spring so that the bottom part of the fork is free to come off but it wont pull out of the top part. I have oiled it and tapped it with a...

I want to paint my shocks. For the life of me I can't figure out how to get them apart. Now! I know there are a few of you that can guide me thru the process. As you can see I am replacing the orginal with adjustable so an older than average guy can keep the fender off the tire. I don't know...