Can anyone tell me if the drain plug on a Honda gc160 is metric thread or standard pipe thread
Would like to extend it a bit. Always like to have the right parts before I start
Thanks in advance
Craig
I am looking for suggestions on replacing my drain plugs on my Predator. It is going in a Barstool and the engine plate is mounted below the frame so the fore and aft movement is limited because of the drain plugs. They are a 10 X 1.25 thread. I want a button head allen to replace them but no...
Hi, could anyone tell me what size oil drain plug (magnetic) to get for the stock engine?
I've got magnetic plugs on all my other toys and would love to know where to buy one for the MB200.
Thanks!
I was wondering when I have to change the oil in my go kart its in a tight spot, so is there any way I can get rid of the drain plug and attach a tube on it with a small valve?
Also when do I change my oil, I will be using it in the winter so before?
Hey Fellas, I'm missing a couple of bits for this Tecumseh I'm rebuilding. I could use a couple of screws like the one pictured for the plastic tank. I also need two drain plugs with the square end so I can remove the extension that is shown in the pic. Please, let me know if you have a donor...
This seems like it would be a common issue. But my drain plug dumps out onto the motor mount plate. What are people doing to keep oil changes cleaner? Advice and pic welcome. Honda gx140 on a manco streaker.
Hey all, for sale I have a old "soup can" styled gas tank. Came off a lauson/tecumseh lawnmower. The inside has some minor surface rust starting and the outside is dirty. About 3" round and 8" long. The filler is in the center and the drain is on the left side and built into the tank, can't...
For those that would like to install a drain plug with a magnet and find them to expensive do as I did. I used neo magnets from Ebay(like item 190941084399) and drilled a recess hole in my motors drain plugs and set a magnet in it. I don't use any adhesive as the magnet is so strong it doesn't...
For those that would like to install a drain plug with a magnet and find them to expensive do as I did. I used neo magnets from Ebay(like item 190941084399) and drilled a recess hole in my motors drain plugs and set a magnet in it. I don't use any adhesive as the magnet is so strong it doesn't...
My Briggs is going to be mounted in a way that I won't have access to the oil drain with out taking the motor out. Anyone have experience with installing a bulkhead fitting type drain on a side cover. I just want to make sure I get something that won't leak.
Thanks in advance.
hope to start mean green this week, the pet cock thats in my tank does nothing and is nasty. i stopped by a few places with no luck....its 1/8 threads into the bottom of my tank. i looked on OldMiniBikes warehouse and didnt see what i was looking for
So If a drain bolt is stripped on one of these things could I use a hand drill and drill the hole a little bigger and tap it? What's the best way to fix it?
Greg
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.